Knobs; Packaging Tape; Stainless Steel Surfaces - GE JS900 - Profile 30'' Slide-In Electric Range Owner's Manual

Care and cleaning of the range.
Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is reengaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
How to Remove Protective Shipping Film and Packaging Tape
Carefully grasp a corner of the protective
shipping film with your fingers and slowly
peel it from the appliance surface. Do
not use any sharp items to remove the
film. Remove all of the film before using
the appliance for the first time.
Control Knobs
The control knobs may be removed for easier
cleaning.
Before removing the knobs for
cleaning, please note that the knobs
are in the OFF position. When replacing
Oven Vent
The oven vent is located above the left side of
the door.
This area could become hot during
oven use.

Stainless Steel Surfaces

Do not use a steel-wool pad; it will scratch
the surface.
Shake bottle well.
Place a small amount of Stainless
Steel Appliance Cleaner on a damp
cloth or damp paper towel.
Clean a small area (approximately
8" x 8"), rubbing with the grain of
the stainless steel if applicable.
Dry and buff with a clean, dry paper
towel or soft cloth.
Repeat as necessary.
NOTE: If a mineral oil-based stainless steel
appliance cleaner has been used before
to clean the appliance, wash the surface
To assure no damage is done to the
finish of the product, the safest way to
remove the adhesive from packaging tape
on new appliances is an application of a
household liquid dishwashing detergent.
Apply with a soft cloth and allow to soak.
NOTE: The adhesive must be removed from all
parts. It cannot be removed if it is baked on.
the knobs, check the OFF position to
insure proper placement.
Wash the knobs in soap and water or
a vinegar and hot water solution but
do not soak.
It is normal for steam to come out of
the vent.
The vent is important for proper air circulation.
Never block this vent.
(on some models)
with dishwashing liquid and water prior
to using the Stainless Steel Appliance
Cleaner. After washing the surface with
dishwashing liquid and water, use a
generous amount of Stainless Steel
Appliance Cleaner to clean the
appliance.
To Order
To order Stainless Steel Appliance
Cleaner, please call our toll-free number:
National Parts Center
ge.com
Stainless Steel Appliance
Cleaner . . . . . . . . . . . . . . . . . . . . . . .# PM10X311
ge.com
800.626.2002
21