Download Print this page
GE JDP47 Installation Instructions Manual
GE JDP47 Installation Instructions Manual

GE JDP47 Installation Instructions Manual

Self-cleaning radiant electric drop-in range

Advertisement

Quick Links

Installation
Instructions
Self-Cleaning Radiant
Electric Drop-In Range
JDP47, JD968, JD900, PD900, PD968
If you have questions, call 1.800.GE.CARES or visit our website at:
GEAppliances.com
Before You Begin
Read these instructions carefully and completely.
« IMPORTANT-save
these
instructions for local inspector's use.
« IMPORTANT -observe
all
governing codes and ordinances.
¢ Note to Installer—Be sure to leave these
instructions with the consumer.
¢ Note to Consumer—Keep these
instructions for future reference.
¢ Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered under
the warranty.
¢ NOTE—This appliance must be properly
grounded.
«ATTENTION INSTALLER
All electric drop-in ranges must be hard wired
(direct wired) into an approved junction box. A
plug and receptacle is NOT permitted on these
products.
2 Shoulder Screws (for
stop device}
Lower Trim
4 Screws
Tools You Will Need
1/8" Drill Bit and Electric
or Hand Drill
etc—
Phillips Screwdriver
Standard Screwdriver
Materials Needed
Nut Driver
Tape Measure
5
(A
Junction Box
Strain Relief Clamp for
Wire Nuts
Hammer
1/2" conduit
Straight Edge
or Square
< =
Pencil
°
Safety Glasses
Hand or Sabre Saw
31-10622-3
02-10
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the JDP47 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Jd968Jd900Pd900Pd968Pd900dp3wwPd968tp3ww