Attach Backguard Or Island Trim - KitchenAid KDRP407HSS Installation Instructions Manual

4-Wire Cable from Power Supply
IMPORTANT: Use the 4-wire cable from power supply where
local codes do not permit connecting the frame-ground
conductor to the neutral (white) junction box wire.
A
B
C
A. Red wires
B. Bare or green wires
C. 4-Wire cable from range
D. Junction box
1. Disconnect power.
2. Remove junction box cover if present.
3. Connect the flexible armored cable from the range to the
junction box using a UL listed or CSA approved conduit
connector.
4. Tighten screws on conduit connector if present.
5. Connect the two black wires together using the UL listed wire
nuts.
6. Separate the factory-crimped bare and white range wires.
7. Connect the two white wires together using the UL listed wire
nuts.
8. Connect the green or bare ground wire from the range cable
to the green or bare grounded wire (in the junction box) using
the UL listed wire nuts.
9. Install junction box cover.
10. Reconnect power.
D
E
F
G
H
E. White wires
F. UL listed wire nuts
G. Black wires
H. UL listed or CSA approved
conduit connector
3-Wire Cable from Power Supply
IMPORTANT: Use the 3-wire cable from power supply where
local codes permit connecting the frame-ground conductor to
the neutral (white) junction box wire (not used for Canadian
installations).
A
B
C
D
E
A. Junction box
B. Red wires
C. White wire (from power supply)
D. White and green grounding
wires (from range)
1. Disconnect power.
2. Remove junction box cover if present.
3. Connect the flexible armored cable from the range to the
junction box using a UL listed or CSA approved conduit
connector.
4. Tighten screws on conduit connector if present.
5. Connect the two black wires together using UL listed wire
nuts.
6. Connect the two red wires together using UL listed wire nuts.
7. Connect the factory-crimped bare and white range cable
wires to the white (neutral) wire in the junction box using UL
listed wire nuts.
8. Install junction box cover.
9. Reconnect power.

Attach Backguard or Island Trim

WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Using 2 or more people, move range close to cabinet
opening.
2. Remove cardboard or hardboard from under range. Move
range into final position.
3. Attach the backguard or island trim as required for your
installation. See "Tools and Parts." Attachment screws are
included in the literature package.
F
G
H
E. 4-Wire cable from range
F. Black wires
G. UL listed or CSA approved
conduit connector
11