The Textbridge Toolbox - ScanSoft TEXTBRIDGE PRO 11 Manual

The TextBridge Toolbox

This Toolbox lets you drive the processing. By default it is located along
the top of the TextBridge desktop, just above the working areas. It can be
floated and also be docked along the bottom of the desktop.
It has three tabs on the left: AutoOCR™, Manual OCR and OCR
Wizard. Click one to see its controls in the Toolbox. The picture at the
beginning of this section showed the TextBridge desktop with the
Manual OCR toolbar. The AutoOCR toolbar looks like this.
Automatic processing is started, and can be stopped and re-started with
the buttons on the right of the toolbar. The use of these buttons is
detailed in chapter 3, Processing documents automatically.
You can switch between automatic and manual processing any time the
program is not busy with processing. That means you can switch between
them while you are working within a document. You can automatically
process some pages, then add more pages with manual processing. After
processing a stack of pages automatically, you can inspect the results and
then go back to reprocess certain pages manually. This procedure is
described in chapter 3, Processing a document automatically and finishing it
manually.
The use of the OCR Wizard is detailed in chapter 3, Processing documents
using the OCR Wizard. TextBridge Pro must be empty when you start the
OCR Wizard. When you have used it to process and save a document, it
remains in the program and can be further processed (adding more pages,
rerecognizing pages etc.) with either manual or automatic processing.
T T B 2 5
H E E X T R I D G E D E S K T O P