ScanSoft TEXTBRIDGE PRO 11 Manual page 14

14 I
NSTALLATION AND SETUP
S
ETTING UP YOUR SCANNER WITH
All files needed for scanner setup and support are copied automatically
during the program's installation. Before using TextBridge Pro 11 for
scanning, your scanner should be correctly installed and tested for correct
functionality. Scanner installation and setup are done through the
Scanner Wizard. You can start this yourself, as described below.
Otherwise, the Scanner Wizard appears when you first try to perform
scanning from TextBridge Pro 11.
Please follow these steps to use the Scanner Wizard to setup your scanner
with TextBridge Pro 11:
Choose Start É Programs É ScanSoft TextBridge Pro 11.0 É
u
Scanner Wizard or click the Setup button in the Scanner panel of
the Options dialog box or choose a scan command in the Get
Page drop-down list in the TextBridge Toolbox.
u
Choose Select scanning source, then click Next.
u
Click once on your scanner's TWAIN driver, then click Next.
u
Choose Yes to test your scanner configuration, then click Next.
u
The wizard will now test the connection from the computer to
your scanner. Click on Next.
u
Insert a test page into your scanner.
u
The wizard is now prepared to do a basic scan using your scanner
manufacturer's software. Click on Next.
u
Your scanner's native user-interface will appear. Click on Scan to
begin the sample scan.
u
If necessary, click on Inverse Image... or Missing Image... and
make the appropriate selections.
u
Once the image appears correctly in the window, click on Next.
u
Select the item that most appropriately describes your scanner,
then click on Next.
u
Click on Next to proceed to page size.
T B P
EXT RIDGE RO