Table of Contents
Advertisement
ABOUT DIRECTV CONTROL
The DIRECTV universal remote control is designed to give
you access to features not found on the original remote
control.It is preprogrammed at the factory to operate a
HNS-manufactured DIRECTV Receiver, so you can skip
this section if you have this brand. However,to use it with
other brands of DIRECTV Receivers,you will need to pro-
gram the remote control by performing the following steps:
Programming DIRECTV Control
1.
Locate the DIRECTV Receiver's brand and
model number (on the back or bottom panel)
and write it in the spaces below.
Brand __________________________
Model # _________________________
NOTE: Please read steps 2-5 completely before pro-
ceeding. Highlight or write down the codes and device
you wish to program before moving on to step 2.
2.
Power on the DIRECTV Receiver.
3.
On the DIRECTV universal remote control,
press DIRECTV once. Press and hold Setup until
the DIRECTV key blinks twice,then release Setup.
4.
Use the Setup Codes for DIRECTV Receivers
(on the next page) to locate the brand name
and code for your specific DIRECTV Receiver.
Then use the keypad to enter the four-digit
code. If performed correctly, the DIRECTV key
will blink twice.
NOTE: If the DIRECTV key emits a long blink, the code
is invalid. Repeat steps 3 and 4 and try entering the
same code again.
5.
Aim the DIRECTV universal remote control at
the DIRECTV Receiver and press Power once.
The DIRECTV Receiver should turn off. If it
does not, repeat steps 3 and 4, trying each
code for your brand until you find one that
works. If it still does not work, try Searching
For Your Code on page 23.
6.
For future reference, write down the working
DIRECTV code in the following box:
DIRECTV CODE
9
continued on next page...
Hide quick links:
Advertisement
Table of Contents
