Table of Contents
Advertisement
PROGRAMMING OTHER DEVICE CONTROL
(continued)
TV
VCR
AUX
PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo, perform the following
instructions to control this device:
1.
Turn on your TV/VCR Combo and insert a
video cassette.
2.
On the DIRECTV universal remote control,
press VCR once. Press and hold Setup until the
VCR key blinks twice, then release Setup.
3.
Use the Setup Codes For TV/VCR Combos (on
page 19) to locate the brand name and then
enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure correctly,
the VCR key will blink twice.
NOTE: If the VCR key did not blink twice after enter-
ing the code's last digit, then repeat steps 2 through 3
and try entering the same code again.
4.
Aim the DIRECTV universal remote control at
your TV/VCR Combo and press Power once.
The unit should turn off. If it does not respond,
repeat steps 2-3, trying each code listed for your
brand until you find one that works. If it still
does not work, try Searching For Your Code on
page 23.
5.
If you've located a TV/VCR setup code that
works your TV/VCR Combo and a separate TV
code is also listed, you'll need to program this
code into the DIRECTV universal remote con-
trol to access volume control (see Programming
Other Device Control on the previous page).
12
Hide quick links:
Advertisement
Table of Contents
