Re-Assigning Device Keys - DirecTV UNIVERSAL REMOTE CONTROL User Manual

RE-ASSIGNING DEVICE KEYS

The DIRECTV universal remote control can be set up to
control a second TV or VCR, or any combination of up
to four home entertainment devices. For example, to
have the DIRECTV universal remote control a TV, a
DIRECTV Receiver, and two VCRs, you will need to
re-assign the unused AUX key to operate the second VCR
as follows:
1. On the DIRECTV universal remote control,
press AUX once. Then press and hold Setup
until the AUX key blinks twice, then release
Setup.
Enter 9 - 9 - 2.
2.
Press VCR once, then press AUX once. The
3.
AUX key will blink twice.
The AUX key is now ready to be programmed
4.
for your second VCR. See Programming Other
Device Control on page 11.
To re-assign other device keys, repeat steps 1 to 4 and
substitute the key sequence using the following chart:
To Re-Assign
VCR as 2nd TV key:
VCR as 2nd AUX key: Setup - 9 - 9 - 2 - AUX - VCR
VCR as 2nd
DIRECTV key:
VCR back to VCR:
AUX as 2nd TV key:
AUX as 2nd VCR key:
AUX as 2nd
DIRECTV key:
AUX back to AUX:
Upon completion of a re-assignment, the selected mode
key will blink twice to confirm your selection. Then, you'll
need to program device control (see Programming Other
Device Control on page 11).
Perform Key Sequence
Setup - 9 - 9 - 2 - TV - VCR
Setup - 9 - 9 - 2 - DIRECTV - VCR
Setup - 9 - 9 - 2 - VCR - VCR
Setup - 9 - 9 - 2 - TV - AUX
Setup - 9 - 9 - 2 - VCR - AUX
Setup - 9 - 9 - 2 - DIRECTV - AUX
Setup - 9 - 9 - 2 - AUX - AUX
26