Table of Contents
Advertisement
Waist-High
Burner
(Self Clean Models)
Lower
Ove_ Bottom
Air Shutter
(Removable)j
To remove the oven bottom, remove oven hold down screws
at rear ofoven bottom. Pull up at rear, disengage front of oven
bottom from oven front frame, and pull the oven bottom out
of the oven. Remove burner baffle so that the burner flame
can be observed.
If the flame is yellow in color, increase air shutter opening
size. (See "2" in illustration below.) If the flame is a distinct
blue, reduce the air shutter opening size.
To adjust loosen lock screw (see "3" illustration
below),
reposition air shutter, and tighten lock screw. Replace oven
bottom.
Lock Screw
(_Air
Shutter
Oven
Burner
Tube
®
Orifice
Hood
11.Air
Shutter-Broil
Burner
The approximate flame length of the broil burner is 1 inch
(distinct inner, blue flame).
To determine if the broil burner flame is proper, set the oven
to broil.
If the flame is yellow in color, increase air shutter opening
size. (See "2" in illustration above.) If the flame is a distinct
blue, reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in illustration above),
reposition air shutter, and tighten lock screw.
12.Make
Sure Range is Level.
Level the range by placing a level horizontally on an oven
rack. Check diagonally from front to back, then level the
range by either adjusting the leveling legs or by placing shims
under the corners of the range as needed
Model and Serial Number Location
For sealed bumer ovens, the identification plate is located on
the right-hand surface of the oven front frame at the storage
or warmer drawer; or the lower panel area.
When ordering parts for or making inquires about your range,
always be sure to include the model and serial numbers and
a lot number or letter from the identification
plate on your
range.
Your identification plate also tells you the rating of the burners,
the type of fuel and the pressure the range was adjusted for
when it left the factory.
Care, Cleaning and Maintenance
Refer to the Use & Care Guide for cleaning instructions.
If removing the range is necessaryforcleaning
or maintenance,
shut off gas supply. Disconnect the gas and electrical supply.
If the gas or electrical supply is inaccessible,
lift the unit
slightly at the front and pull out away from the wall. Pull only
as far as necessary to disconnect
the gas and electrical
supply. Finish removing the unit for servicing and cleaning.
Reinstall in reverse order making sure to level the range and
check gas connections for leaks. See page 3,
step 1 for proper anchoring instructions.
Before You Call for Service
Read the "Before You Call" and operating instruction sections
in your Use & Care Guide. It may save you time and expense.
The list includes common occurrences that are not the result
of defective workmanship
or materials in this appliance.
Refer to the warranty in your Use & Care Guide for our toll-
free service number and address. Please call or write if you
have inquiries about your range product and/or need to order
parts.
13. After installation
is complete,
make sure all
controls
are left in the OFF position.
Open warmer drawer.
Serial plate location is here
8
Advertisement
Table of Contents
