Care & Cleaning; Before You Call For Service; Model And Serial Number Location - Kenmore 7560 30" Gas Range Installation Instructions Manual

30" gas range
Table of Contents

Advertisement

Oven
Burner
Tube
11. Air Shutter-Broil
Burner
The approximate
flame length of the broil burner is 1 inch
(distinct inner, blue flame).
To determine if the broil burner flame is proper, set the oven
to broil.
If the flame is yellow in color, increase air shutter opening
size. (See "2" in illustration above.) If the flame is a distinct
blue, reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in illustration above),
reposition air shutter, and tighten lock screw.
Care, Cleaning
and Maintenance
Refer to the Use & Care Guide for cleaning instructions.
If removing
the
range
is necessary
for cleaning
or
maintenance,
shut off gas supply. Disconnect the gas and
electrical supply. If the gas or electrical supply is inaccessible,
lift the unit slightly at the front and pull out away from the wall.
Pull only as far as necessary to disconnect the gas and
electrical supply. Finish removing the unit for servicing and
cleaning. Reinstall in reverse order making sure to level the
range and check gas connections for leaks. See page 3,
step 1 for proper anchoring instructions.
Before You Call for Service
Read the "Before You Call" and operating instruction sections
in your Use & Care Guide. It may save you time and expense.
The list includes common occurrences that are not the result
of defective workmanship or materials in this appliance.
Refer to the warranty in your Use & Care Guide for our toll-
free service number and address. Please call or write if you
have inquiries about your range product and/or need to order
parts.
12. Make Sure Range is Level.
Level the range by placing a level horizontally on an oven
rack. Check diagonally from front to back, then level the
range by either adjusting the leveling legs or by placing shims
under the corners of the range as needed.
13.After
installation
is complete,
make sure all
controls
are left in the OFF position.
Model and Serial Number Location
For sealed bumer ovens, the identification plate is located on
the right-hand surface of the oven front frame at the storage
or warmer drawer; or the lower panel area.
When ordering parts for or making inquires about your range,
always be sure to include the model and serial numbers and
a lot number or letter from the identification
plate on your
range.
Your identification
plate also tells you the rating of the
burners,
the type of fuel and the pressure the range was
adjusted for when it left the factory.
_ _
_
iiiiiiiii
ii_
_i_iiiii i_
_
Serial plate location:
Open storage or warmer drawer,
located on right side of range frame.

Advertisement

Table of Contents
loading

This manual is also suitable for:

7560

Table of Contents