Directed Electronics NONE AM5 Owner's Manual page 11

Integrated
LED/Valet ® switch
Open the door and the alarm sounds.
Turn the ignition to the "run"
position. Press and release
the integrated LED/Valet
button, within 10 seconds.
After a few seconds the LED stops flashing, the
alarm shuts off, and the vehicle starts. If it does not, you may have
waited too long. Turn the ignition off and try again.
n n o o t t e e : : The setting for the number of times the integrated
LED/Valet switch must be pressed is set in the Programming
Section of this guide.
8
LED status indicator
DRW-35
© 2008 Directed Electronics All rights reserved