Dacor ILHSF10 Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Dacor Manuals
  4. Ventilation Hood
  5. ILHSF10
  6. Installation instructions manual

Dacor ILHSF10 Installation Instructions Manual

In-line blower
Hide thumbs Also See for ILHSF10:
Table of Contents

Advertisement

Quick Links

See also: Manual
Installation Instructions
In- Line Blower
Models: ILHSF8, ILHSF10
Suitable for use in a household cooking area.
Suitable for use with solid state controls.
To complete this blower, the hood assembly must be purchased separately.
See the hood installation instructions to determine suitability.
Part No. 103719 Rev. E

Advertisement

Table of Contents
loading

Related Manuals for Dacor ILHSF10

Summary of Contents for Dacor ILHSF10

  • Page 1 Installation Instructions In- Line Blower Models: ILHSF8, ILHSF10 Suitable for use in a household cooking area. Suitable for use with solid state controls. To complete this blower, the hood assembly must be purchased separately. See the hood installation instructions to determine suitability.

  • Page 2: Table Of Contents

    Dacor Distinctive Service (for repairs under warranty only) Phone: (877) 337-3226 (U.S.A. and Canada) Monday — Friday 6:00 . to 4:00 . Pacific Time All specifications subject to change without notice. Dacor assumes no liability for changes to specifications. © 2008 Dacor, all rights reserved.

  • Page 3: Important Safety Instructions

    Hazards or unsafe practices that COULD result in severe • Always contact the Dacor Customer Service Team personal injury or death. about problems and conditions that you don’t under- stand. See Customer Service Information above.

  • Page 4: General Safety Precautions

    Install or locate this appliance only in accordance • Do not route electrical wiring near hot surfaces. with these installation instructions and the Dacor hood or downdraft vent installation instructions. • Do not ground the appliance with the neutral (white) Improper installation, adjustment, alteration, service house supply wire.

  • Page 5: Product Specifications

    9 1/8” (23.2 cm) 19” (48.3 cm) 15 1/4” (38.7 cm) Air Flow 2 1/4” (5.7 cm) 16” 10” REF 10” REF (40.6 cm) (25.4 cm) (25.4 cm) 8 1/4” 10 3/4” (21.0 cm) (27.3 cm) 15 3/4” ILHSF10 (40.0 cm)

  • Page 6: Electrical Specifications

    The power for this blower is supplied via 1/2” 3-wire WARNING conduit (not included) by an approved Dacor hood or raised vent. The conduit is installed between the hood To avoid the risk of fire due to the unit overheating: or raised vent and the blower and shall be terminated •...

  • Page 7: Installation Instructions

    Installation Instructions Installation Preparation Electrical Installation Run the conduit line used to supply power from the Verify Package Contents installed raised vent or hood to the in-line blower paral- lel to the duct work. • Blower assembly Make sure that power to the raised vent or hood is Parts Required disconnected or turned off at the circuit breaker or fuse box.

  • Page 8: Verifying Proper Operation

    Replace the blower electrical access panel. Dacor is not responsible for the cost of correcting problems Secure the other end of the conduit to the hood or caused by a faulty installation.

  • Page 9: Technical Data

    Rating* ILHSF8 600 CFM 650.7 CFM ILHSF10 1100 CFM 1115.9 CFM * At zero inches static pressure ILHSF10 Blower Performance ILHSF8 Blower Performance 1000 1200 Airflow CFM (Cubic feet/minute) Airflow CFM (Cubic feet/minute) Wiring Diagram Terminal PSC “Type E” Motor...

  • Page 10: Notes

    Notes...
  • Page 12 Dacor ● Phone: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com...

This manual is also suitable for:

Ilhsf8

Table of Contents