Sanyo PDG-DET100L - SXGA+ DLP Projector Owner's Manual page 21

For the Projector which provides the Network sub menu in the Setting main menu
2
Configuration for IP Address/ Subnet mask/Default Gateway*/DNS*
Press the SELECT button again, the following network setting menu appears on
the screen. Enter the specified network address with the point buttons (d e 7
8). The following is an example of a network configuration.
NETWORK SETTING
IP Address
How to enter the numbers
To move the selection and change the values, use the point buttons (d e 7 8) on
the projector or on the remote control.
The point buttons 7 8 are used to select the column.
The point buttons d e are used to change the numbers up and down.
3
Restart the Network board
Select the SET with the point buttons ( 7 8) and press the SELECT button again.
The network configuration display disappears and the network board begins
restarting* . It takes about 40 seconds. Do not turn off the mains switch during
1
this period.
Completing of installation
Now the installation is completed. The IP address of this projector is set to
"192.168.1.201".
* In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0]. If you do not use the functions E-mail or DNS server, it should also
be set to [0.0.0.0] for the DNS address.
192 168
255 255
Sub net
192 168
Gateway
0
DNS
1 201
255 0
1 1
0 0 0
SET CANCEL
Network configuration
Network Board
OWNER'S MANUAL
21