2.Factory layer:
1) DMD layer (Fig-3):
1.1) CW delay: adjust color wheel delay. (Note this value Before Upgrade
Software)
1.2) White peak: adjust DMD white peak. In PC mode default value set 10, in
Video mode is 0.Software auto set this value as source find.
1.3) DLP Brightness: adjust DLP Brightness. default setting is 36.Do not
change this value .
1.4) DLP Contrast: adjust DLP Contrast. Default setting is 30.Do not change
this value.
1.5) Burn-In Hour: set how many hours to burn-in. You can enable burn-in on
next selection.
1.6) Burn-In: after you set burn-in hours, set this selection to On and system
will going to burn-in immediately. You can see color change (red, green,
blue, black, white) on screen in turn. System will auto turn off after burn-in
hour count down to 0 and burn-in complete. (You can also cancel burn-in
sequence by set this selection to Off).
(Fig-3) DMD layer
39