Presentation Timer Command; Keystone Up Command; Keystone Down Command; State Read Command - Canon LV S3 - SVGA LCD Projector Specification

7.49

Presentation Timer Command

Command
Detail
Response
7.50

Keystone Up Command

Command
Detail
Response
7.51

Keystone Down Command

Command
Detail
Response

8. State Read Command

8.1 Format

8.1.1 A PC issues commands fin format as below.
"C‚q•h COMMAND [CR]
Command: 1 character (See Basic Status Read Command Table)
8.1.2 When a projector receives the appropriate command, it returns a character line as the
required data.
Required Data [CR]
Required Data: A character line (See Basic Status Read Command Table)
8.1.3 When receiving data cannot be decode, the projector returns, ""?" [CR].
"C8A" [CR]
Set a presentation timer to active.
This command works the same as the remote control's "P-TIMER" button.
Acceptable [ACK] [CR]
Unacceptable "?" [CR]
"C8E" [CR]
Adjust keystone. Make the screen image length at the top edge shorter.
Acceptable [ACK] [CR]
Unacceptable "?" [CR]
"C8F" [CR]
Adjust keystone. Make the screen image length at the bottom edge shorter.
Acceptable [ACK] [CR]
Unacceptable "?" [CR]
Page 16/21