Quick Reference Guide - Directed Electronics Security System and Convenience 125xv User Manual

QUICK REFERENCE GUIDE:

To lock/arm using your remote
■ To arm the system press
nected). The LED will begin to flash. The Failsafe
vent the vehicle's starter from cranking if it has been installed. The ve-
hicle's horn (if connected) will honk and the parking lights will flash
once to confirm arming of the system.
To unlock/disarm using your remote
■ To disarm the system press
be deactivated and the vehicle's horn (if connected) will honk twice and
the parking lights will flash twice.
Disabling the Failsafe
■ Turn on the ignition. Press and release the Valet
onds. The LED will stop flashing and the vehicle should start. Be sure to
check with the installer for the location of the Valet
To remote start the vehicle
■ Press
cle will start and run for the programmed amount of time.
To enter or exit Valet
■ Turn the ignition to the "ON" position. Turn the ignition back off. Press
and release the Valet
light steadily if you have entered Valet
repeat the steps above. The LED will turn off when exiting Valet
To activate Panic Mode
■ Press and hold
To disable the remote start system
■ To disable the remote start, move the shutdown toggle switch to the OFF
position.
Location of Shutdown Switch______________________________
2004 Directed Electronics, Inc.
©
for one second. The doors will lock (if con-
®
Starter Kill without a transmitter
. The parking lights will turn on (if connected) and the vehi-
®
Mode
®
switch within 10 seconds. The status LED will
for 1.5 seconds.
®
for one second. The doors will unlock (if
connected). The Failsafe
®
switch within 10 sec-
®
Mode. To exit Valet
Starter Kill will pre-
®
Starter Kill will
®
switch.
®
Mode,
®
Mode.
33