Step 7; Step 8 - Directed Electronics G312R Owner's Installation Manual

step 7

Horn Honk
This wire provides a negative pulsed output for audible confir-
mation of the door locks through the horn. Locate the suspected
horn wire using the information sheet for your specific vehicle.
With the red lead of the meter attached to a 12-volt constant
source, connect the black lead to the suspect horn wire and honk
the horn. The meter should read between 11.00 and 12.00 volts.
Once the horn wire has been identified, strip off enough insula-
tion off this wire to solder the BROWN (H1/10) wire from the
12-pin main harness to the horn wire and cover the solder
connection with black tape.
note: The BROWN (H1/10) wire is a low current out-
put. It is intended only to drive a relay which controls the
horn. Connecting this wire directly to the horn w w i i l l l l result
in damage to the keyless entry system.

step 8

Dome light supervision (optional)
The dome light wire is optional and not required for normal
operation, however if desired you can have the security system
turn on the dome light when the system is disarmed. If you
would like this feature please refer to the web site or call tech-
nical support.
30 © 2003 directed electronics, inc.