Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1 Manual page 46

Network and Security Manager 2010.4 API Guide
Table 12: Backdoor Rulebase Data Elements (continued)
Data Element
ruleno
preferred-id
comments
rb-link
customOptions_collection
enabled
src_zone_collection
src_addr_collection
src_addr_negate
dst_zone_collection
dst_addr_collection
dst_addr_negate
service
28
Description
Rule number.
A rule ID is a number that uniquely identifies a rule within the
rulebase and security policy. After you install a rule as part of
a security policy on a security device, you can view the rule by
logging in locally to the device. However, when you view it
through the Web UI or CLI, the rule appears as an individual
policy. The individual policy on the device has the same ID as
the rule in the management system, enabling you to determine
which rules are on specific devices.
Comments about the backdoor rules.
Rule group name.
Custom options.
Collection enabled.
The source sends traffic from this zone.
Address of the traffic source.
Negates the specified source address.
The source sends traffic to this zone.
Destination address for the traffic.
Negates the specified destination address.
These service object rules specify the service that an attack
uses to access the network.
Copyright © 2010, Juniper Networks, Inc.