Installing Hood Canopy - Viking VBCV4238 Installation Instructions Manual

INSTALLING HOOD CANOPY

(VBCV/VICV Custom Ventilator Kits Only)
A*
B*
Bottom Cutout Dimensions
*For best results, center the Make sure the back wall of
unit over the burners of the
the custom hood canopy is
cooking product (front to
flush with the cutout so the
back; right to left). ventilator system may be
mounted as shown below.
Custom Hood Canopy Cutouts
1) Position ventilator
system inside of the
custom hood canopy
and center it front to
back and left to right.
2) Bottom mounting holes
fasten ventilator system
to bottom of custom
hood canopy with the
screws provided
Wall Hoods
A
30" W. 27 7/16" (69.7 cm)
36" W. 33 7/16" (84.9 cm)
42" W. 39 7/16" (100.2 cm)
48" W. 45 7/16" (115.4 cm)
54" W. 51 7/16" (130.7 cm)
60" W. 57 7/16" (145.9 cm)
66" W. 63 7/16" (161.1 cm)
Island Hoods
A
36" W. 33 7/16" (84.9 cm)
42" W. 39 7/16" (100.2 cm)
54" W. 51 7/16" (130.7 cm)
66" W. 63 7/16" (161.1 cm)
A
B
Custom Hood Canopy
Built-in Ventilator System
3) OPTIONAL
Rear mounting holes fasten
ventilator system to rear of
custom hood canopy.
6
INSTALLING ROUGH-IN PLATE AND CONNECTING DUCT - INTERNAL POWER
(Also see instructions supplied with ventilator kit)
B
1. Attach rough-in plate to studs in the inside, top of hood with four (4) #10-24 nuts provided.
21 7/16" (54.5 cm)
2. Connect ductwork using supplied transition and damper (transition and damper are part of rough-in plate on some
21 7/16" (54.5 cm)
models). Use duct tape to make all joints secure and air tight. In some installations, it is easier to attach transition
21 7/16" (54.5 cm)
to plate before attaching plate to hood.
21 7/16" (54.5 cm)
3. Remove wire box cover. Remove a knockout from the wiring box. Feed 6" of power cable through opening and
21 7/16" (54.5 cm)
attach cable to wiring in wiring box with appropriate connector. WARNING: MAKE SURE ELECTRICAL SUPPLY IS
21 7/16" (54.5 cm)
OFF.
21 7/16" (54.5 cm)
4. Wire black to black, white to white, and green or bare wire beneath green ground screw. Replace wire box cover.
B
27 9/16" (70.0 cm)
27 9/16" (70.0 cm) Studs
27 9/16" (70.0 cm)
27 9/16" (70.0 cm)
Nuts
5. Plug the rough-in plate power cord into the receptacle located on the top side of the light panel.
Receptacles are located behind
and above control panel.
Rough-in
Plate
3-prong power
supply plug-in
2-prong blower plug-in
7
Top of Hood
Studs
Wire box cover
Nuts