Advertisement
PREPARING FOR HOOD INSTALLATION
Plan where the ductwork will be located. See pages 11-14 for rough-in dimensions. Install proper-sized duct work,
and roof or wall cap for the type of blower you are using. Recommended hood locations for the most common
installations are shown on page 2.
Adjust your measurements for various heights of ceilings, soffits, cabinets, or ranges/rangetops.
1200 CFM
Single Blower
Roof Cap
Interior Power -
Typical Ductwork
10" Round Duct
Duct Cover or
Soffit
ELECTRICAL SUPPLY
Run 120 VAC electrical power cable from service panel to installation location. See "Basic Specifications" on page 15
for the maximum amp requirements.
(BEFORE INSTALLING ISLAND HOOD CANOPY, SKIP TO PAGE 5)
INSTALLING HOOD CANOPY
Center the canopy and attach to wall. Secure
the hood to wall with mounting screws
provided. Make sure that the mounting screws
are driven into the framing and not just the
drywall. Use additional mounting screws (and
wall anchors if necessary) in the other holes.
NOTE: BECAUSE OF THE WEIGHT OF THE
HOOD - MAKE SURE THAT THE MOUNTING
SCREWS ARE DRIVEN INTO THE FRAMING
AND NOT JUST THE DRYWALL. IT MAY BE
NECESSARY TO DRILL ADDITIONAL HOLES
IN THE CANOPY FOR PROPER ALIGNMENT.
Roof Cap
7" Round Duct
Duct Cover
or Soffit
300 -or 600 CFM
Single Blower
Interior-Power
Typical Ductwork
Exterior Blower
10" Round
Duct
Top Mounting Holes
(Soffit or duct cover)
4
900, 1200, or
1500 CFM
Exterior Power
Typical Ductwork
Duct Cover or
Soffit
Advertisement
