Receiving When An Answering Machine Is Connected: Ansmode - Canon Color imageCLASS 8180c Facsimile Manual

4
Press [ (-)] or [ (+)] to select <FAX/TEL OPT. SET> ➞ press [Set]
twice.
5
Press [ (-)] or [ (+)] to select the time 0 to 30 seconds that the
machine takes to check whether a call is fax or voice call ➞ press
[Set] twice.
6
Press [ (-)] or [ (+)] to select the length of time 15 to 30 seconds
that the machine rings when the call is a voice call ➞ press [Set]
twice.
7
Press [ (-)] or [ (+)] to select whether the machine switches to
receive mode or disconnects the call if no one answers a voice
call after the specified time in step 6 ➞ press [Set].
5
You can select from the following:
- <RECEIVE> to switch to receive mode
- <DISCONNECT> to disconnect the call
8
Press [Stop/Reset] to return to the standby display.
Receiving When an Answering Machine Is Connected:
AnsMode
If you want to select <AnsMode>, check the following:
■ Select This Mode If:
•
you only have one telephone line for both fax and telephone use.
•
you want to receive faxes automatically and receive voice messages on your answering
machine.
■ You Will Need to:
set <AnsMode>. (See "Setting the Receive Mode," on p. 5-1.)
NOTE
Follow the guidelines below to adjust the answering machine:
- Set the answering machine to answer on the first or second ring.
- The entire message should be no longer than 15 seconds.
- In the message, tell your callers how to send a fax.
5-4 Setting the Receive Mode