Gsm7328Fs Rear Panel - NETGEAR GSM7352SNA - Prosafe 48 Port Gigabit L3 Managed Stackable Switch Installation Manual

Managed Stackable Layer 3 Switches GSM7328S, GSM7352S and GSM7328FS Hardware Instal-
Table 2-3. LED Descriptions for GSM7328FS (continued)
LED
4-10GbE interface
Module
One LED /module
RPS LED

GSM7328FS Rear Panel

The rear panel has two module bays, a console port, redundant power supply
connector, and a standard AC power receptacle for the supplied power cord. The
module bays support any combination of either the ProSafe 10-Gigabit Ethernet
XFP Adapter (AX741) or the ProSafe 24-Gigabit Stackable Module (AX742).
Stacking/XFP
module bays
Figure 2-6
Introduction
Description
XFP Module Present or Stacking Adapter Present & ACT
LED :
XFP Module Present LED /ACT:
• Off: 10GbE adapter absent
• Solid Green: 10GbE adapter present
• Blinking Green: Packet transmission or reception is occurring
on the port
Stacking Adapter Link/ACT LED
• OFF: Stacking module absent
• Solid Green: Stacking module present
• Blinking Green: Packets transmission or reception is
occurring on the port
• Solid Green: NETGEAR RPS Bank connected (Using internal
Power)
• Solid Yellow: The Switch internal power has failed or been
disconnected , but the RPS is providing power to switch
• Blinking Yellow: RPS unit is present but the power has failed.
• Off: NETGEAR RPS Bank Disconnected.
Redundant
power supply
connector
v1.0, February 2007
Power receptacle
Console
2-9