Figure 35: Cfeb - Juniper M10I Hardware Manual

M10i Multiservice Edge Router Hardware Guide
104
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
If you are removing the active SIB or CFEB-E, press and hold the online/offline button
3.
on the faceplate until the yellow LED labeled
(The effect of removing the active SIB or CFEB-E depends on whether a second SIB
or CFEB-E is installed.
Loosen the thumbscrew on each ejector lever (shown in Figure 35 on page 104), using
4.
a Phillips screwdriver if necessary.
Pull the end of each ejector lever outward until it is nearly perpendicular to the CFEB
5.
or CFEB-E faceplate.
Grasp the ejector levers and pull firmly to slide the CFEB or CFEB-E about halfway
6.
out of the chassis.
Place one hand under the CFEB or CFEB-E to support it, slide it completely out of the
7.
chassis, and place it on the antistatic mat or in the electrostatic bag.
CAUTION: When a CFEB or CFEB-E is out of the chassis, do not hold it by
the ejector levers. They cannot support its weight.
Do not stack CFEBs or CFEB-Es on top of or under other components.
Place each one individually in an electrostatic bag or on its own antistatic
mat on a flat, stable surface.

Figure 35: CFEB

FAIL lights, which takes about 5 seconds.
Copyright © 2010, Juniper Networks, Inc.