NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Hardware Installation Manual page 16

Managed Stackable Layer 3 Switches GSM7328S v2 and GSM7352S v2 Hardware Installation
Table 2-2. GSM7352S v2 LED Description (continued)
LED Description
M1, M2 XFP Module present or Stacking Adapter present and ACT LED
High-Speed I/O XFP Module present LED /ACT
Modules • Off: The 10GbE Adapter is not present or present but link down
(1 LED per with system.
module) • Solid green: The 10GbE Adapter is present and link up with
system.
• Blinking green: Packets transmission or reception is occurring on
the port.
Stacking Adapter Link/ACT LED
• Off: Stacking module is not present or present but link down wih
system.
• Solid green: Stacking module is present and link up with system.
• Blinking green: Packets transmission or reception is occurring on
the port.
SFP ports • Off: No SFP module link is established on the port.
• Solid green: A valid 1000Mbps SFP module link is established on
the port.
• Blinking green: Packet transmission or reception is occurring on
the port at 1000Mbps.
• Solid yellow: A valid 100Mbps SFP module link is established on
the port.
• Blinking yellow: Packet transmission or reception is occurring on
the port at 100Mbps.
Note: If port 43~48 media is changed to copper, the SFP LEDs
change to OFF status.
SFP+ Ports SPD/Link/ACT LED:
(1 Link/ACT LED • OFF: No SFP module link is established on the port.
per port) • Solid green: A valid 10Gbps SFP+ module link is established on
the port.
• Blinking green:Packet transmission or reception is occurring on
the port at 10Gbps.
2-6
v1.0, July 2009
Introduction