NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Hardware Installation Manual page 15

Managed Stackable Layer 3 Switches GSM7328S v2 and GSM7352S v2 Hardware Installation
The table below describes the GSM7352S v2 LEDs on the front of the switch.
Table 2-2. GSM7352S v2 LED Description
LED Description
ID This is the stack member ID (1–8) that the software assigns to the
switch.
Master • Green: The switch is a master unit in a stack of GSM7300S series
switches.
• Off: The switch acts as a slave unit in a stack of GSM7300S
switches.
RPS • Solid green: The redundant power supply is connected (and using
(redundant power ipower module's power).
supply) • Solid yellow: The power module's has failed or been
disconnected, but the redundant power supply is providing power
to the switch.
• Blinking yellow: The redundant power supply unit is present but
the power has failed.
• Off: The redundant power supply is disconnected or not present.
Fan • Solid green: Fan operating normally.
• Solid yellow: Fan has failed
• Off: No fan detected.
PWR (Power) • Solid green: Power module is present and is supplies power to the
the switch and is operating normally.
• Solid yellow: System is in boot-up stage.
• Blinking yellow: POS/ CPU system has failed.
• Off: Power is disconnected.
10/100/1000M Link/ACT LED
Ports (2 LEDs per • Off: No link is established on the port.
port) • Solid green: A valid link is established on the port.
• Blinking green: The port is sending or receiving packets.
SPD LED
• Off: No link is established on the port.
• Solid yellow: A valid 10/100 Mbps link is established on the port.
• Solid green: A valid 1000 Mbps link is established on the port.
Note: If port 41~48 media changes to SFP, the RJ-45 LEDs change
to OFF status
Introduction
v1.0, July 2009
2-5