Manual Configuration/Internet Setup; D-Link Dir-827 User Manual Manual Configuration/Internet Setup; Dynamic (Cable) - D-Link DIR-827 User Manual

Section 3 - Configuration
My Internet Select Dynamic.IP.(DHCP) to obtain IP Address information automatically
Connection: from your ISP. Select this option if your ISP does not give you any IP numbers
to use. This option is commonly used for cable modem services such as
Comcast and Cox.
Host Name: The Host Name is optional but may be required by some ISPs. Leave blank
if you are not sure.
Use Unicasting:
Check the box if you are having problems obtaining an IP address from
your ISP.
DNS Servers:
Enter the Primary and secondary DNS server IP addresses assigned by your
ISP. These addresses are usually obtained automatically from your ISP. Leave
at 0.0.0.0 if you did not specifically receive these from your ISP.
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1500 is the default
MTU:
MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Clone.Your.PC's.MAC.Address button to
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-827 User Manual

Manual Configuration/Internet Setup

Dynamic (Cable)

25