Configuring the Ethernet Management Port
Configuring an IP Address and Subnet Mask for the Ethernet
Management Port
Cisco Content Services Switch Getting Started Guide
2-10
You cannot specify an Ethernet management port IP address that matches or
•
overlaps an IP address, VIP range, or static route previously set for one of the
Ethernet interface ports. If you attempt to specify an overlapping or matching
IP address, the CSS displays an error message and stops you from completing
the command entry.
The Ethernet management port supports SNMP requests to retrieve CSS port
•
information. The CSS Enterprise MIBs, however, do not return data for the
Ethernet management port.
This section includes the following procedures:
Configuring an IP Address and Subnet Mask for the Ethernet Management
•
Port
Configuring Static Routes for the Ethernet Management Port
•
Configuring a Default Gateway for the Ethernet Management Port
•
•
Discarding ICMP Redirects on the Ethernet Management Port
Shutting Down the Ethernet Management Port
•
To access the Ethernet management port on the CSS, you must assign an IP
address and a subnet mask. When setting the Ethernet management port IP
address, note that:
The IP address must be on a different subnet than any other CSS VLAN
•
circuit IP subnets. If you do not make the Ethernet management port IP
address unique, you cannot access the port.
•
An IP address of 0.0.0.0 for the Ethernet management port is a legal setting
and disables the management port upon reboot. If you enter 0.0.0.0, and
attempt to use the subnet mask command, the following message appears:
The mask cannot be set because the IP address is 0.0.0.0
Use the ip address command to configure an IP address for the Ethernet
management port. Use the subnet mask command to configure the subnet mask
for the Ethernet management port. Both commands are available in boot mode.
You must reboot the CSS for the new Ethernet management port IP address and
subnet to take effect.
Chapter 2
Configuring CSS Basics
.
OL-6037-01