Connecting A Powerline Av Ethernet Adapter To The Router - NETGEAR XAV2001 - Powerline AV Ethernet Adapter User Manual

Connecting a Powerline AV Ethernet Adapter to the Router

1. Plug a Powerline AV Ethernet Adapter into a power outlet near your router.
Use the supplied gray Ethernet cable to connect from the Adapter to a LAN port on your router
so that the Powerline network can gain access to the Internet. The Power and Ethernet lights
on the Powerline AV Ethernet Adapter should turn on.
Note: It is not necessary to disconnect your router from your computer.
Router
Figure 1-3 Connecting the XAV2001 to a Router
2. Once plugged in and power is first applied, check to see that the Power light is on.
3. After approximately 10 seconds, check to see that:
a. The Power light is solid green.
b. The Powerline LED is lit.
c. The Ethernet light is on or blinks.
Installation and Basic Configuration
XAV2001 Powerline AV Ethernet Adapter User Manual
Supplied Ethernet cable
v1.0, November 2009
XAV2001 Powerline
AV Ethernet Adapter
Laptop PC
Desktop PC
1-5