Connecting A Powerline Av Ethernet Adapter To The Router - NETGEAR XAV101v2 - Powerline AV Ethernet Adapter User Manual

XAV101v2 Powerline AV 200 Adapter User Manual
Connecting a Powerline AV Ethernet Adapter to the
Router
1. Plug a Powerline AV 200 Adapter into a power outlet near your router.
Use the supplied gray Ethernet cable to connect from the adapter to a LAN port on your
router so that the Powerline network can gain access to the Internet. The Power and
Ethernet LEDs on the Powerline AV 200 Adapter should turn on.
Note: It is not necessary to disconnect your router from your computer.
Figure 3.
2. Once the adapter is plugged in and power is first applied, check to see that the Power LED
is on.
3. After approximately 10 seconds, check to see that:
a. The Power LED is solid green.
b. The Powerline LED is lit.
c. The Ethernet LED is on or blinks.
Chapter 1. Installation and Basic Configuration | 9