Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 15 Manual page 24

Advanced KDFX
Real-time Control of KDFX
What Can't Be Controlled
You cannot change any parameters through KDFX that would involve a major reconÞguration
of the studio:
¥ Bus assignments on the Input pages
¥ Selecting FX presets on the FXBus pages
¥ Allocation on the FXBus pages
¥ Selecting algorithms within the FX presets
¥ Bus assignments on the Output page
If you want to be able to change any of these in real time, you will have to create a new studio,
link it to a different program or setup, and then call it up using a Program Change command.
In addition, there are a few parameters that can cause serious glitching if they are changed in
real time. The most common of these are the ÒRoom TypeÓ settings in reverb algorithms. While
there is nothing in the software to prevent you from assigning an FXMod to Room Type, you
need to be aware of the potential consequences. See Static FXMods on page 15-27.
Adjust
The Adjust setting is the starting value of the selected parameter when it is under KDFX control,
similar to the entry value of a controller in a setup. This might very well be different from the
value of the parameter when the studio is not under FXMod control, so donÕt get confused. If
you are in Program mode, and this is the current program, the Adjust value takes precedence
over the studioÕs Þxed value, and itÕs the Adjust value that will be called up when you call up
the program.
Source
The Source parameter determines which real-time controlÑinternal, MIDI, etc.Ñis going to
affect the selected studio parameter. As with all K2600 real-time controls, the range of control
sources is very large:
¥ OFF (the parameter is not affected by any source and stays at its Adjust value)
¥ ON (the parameter is set to the maximum value determined by adding the Adjust and
Depth values)
¥ MIDI Continuous Controllers 1-95 (see Note)
¥ Channel State
¥ Pressure
¥ Pitch Wheel
¥ The usual list of controllers, as described in Chapter 4 of the MusicianÕs Reference: ASRs,
FUNctions, Clocks, LFOs, Internal Controls, Random Generators, etc.
Note: Under some circumstances, particularly when the K2600 is in Setup mode, there are certain
restrictions on which MIDI sources you can use.
15-24