Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 15 Manual page 13

pressing Edit, and Þnd those two parameters on the Þrst parameter page (PARAM1). YouÕll see
their values are the same as on the FXBUS page.
EditStudio:FXBUS|PAU:3|Free:1||<>FXBus:1|
FX1||2||Big|Room|||||||||||Aux
Wet/Dry
Out Gain
Allocation:Auto
<more||INPUT||FXBUS||AUXFX3|OUTPUT||more>
Edit
EditMultiFX:PARAM1|||||||||EffectSize:3/3
Algorithm:1|Panaural|Room
||||||||||||||||||||In|Gain|||:0.0dB
Wet/Dry|||:35%||||||Out|Gain||:0.0dB
Room|Size|:16.0m
Pre|Dly|||:4ms|||
HF|Damping:15804Hz
<more||PARAM1|PARAM2||||||||||||||||more>
Figure 15-6 Bus Overrides in Place, But Not Engaged
Press Exit to go back to the FXBUS page.
To engage a bus override, you have to use it, which you do by moving the parameter away from
its nominal value on the FXBUS page. Do that, and then go back inside the FX preset.YouÕll see
that the value of the parameter youÕve changed is now shown as BusMod, meaning that the
FX preset parameter is under the control of the bus override.
:35%|||||Lvl:0ff
:0.0dB|||Bal:0%||||Bal:0%
||Mix
|Lvl:0.0dB
Decay|Time:2.9s
Advanced KDFX
Effects Buses
Exit
15-13