Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 14 Sampling Manual page 24

Sampling and Sample Editing
Editing Samples
6 Reverse
F:Reverse||||Start:0.000||||End:6.000|||
Xfade:0.000|||||Curve:LIN|||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
With this function you can reverse the order of the individual samples between the start and end
positions you set. The Xfade parameter lets you apply a crossfade to the start and end of the
reversed segment. The Curve parameter lets you select a crossfade curve. The available values
are LIN, EXP, COS, EQL, and MIX. These curves are described on page 14-34.
Like the crossfade parameter in the Delete function, this crossfade will also shorten the sample.
The maximum crossfade length is half the length of the reversed segment.
7 Invert
F:Invert|||||Start:0.000||||End:6.000|||
||||||||||||||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
Use this function to invert the waveform of the selected sample range. This reverses the phase of
the sample. You wonÕt hear any difference unless it is played in reference with the original
sample.
The results will vary depending on the type of sample. For an interesting phase effect, make a
copy of a sample, then invert the copy, then assign it to the keymap of a second layer in a
program that uses the original sample in the keymap of the Þrst layer (or set them as the Left
and Right samples in a stereo keymap). Add a delay to one of the layers or keymaps to create the
phase effect.
14-24