Table of Contents
Advertisement
The Equalizer Editor
Each program in the K150X has a graphic equalizer associated with it. Each equalizer provides 8 octave bands with a range
of 12dB boost and 30dB cut for each band.
Whether or not this equalizer is active in any particular layer of the program is controlled by the Equalizer Enable parameter
in the layer editor, which can be set on or off for each layer (see Layer Editing).
The Equalization parameters being edited are those for the currently active program. In order to hear the effects of your
equalization editing, turn on the Equalization Enable switch for the layer or layers you want to apply equalization to (see
Layer Editing).
Each equalizer has eight bands centered about the follow frequencies:
62.5 Hz (shelf)
125 Hz
250 Hz
500 Hz
1 kHz
2 kHz
4 kHz
8 kHz (shelf)
Each band may be boosted by 12dB or cut by 30dB.
Using the Equalizer Editor
1.
Select Equalizer Editing by pressing EDIT CLR
2.
One of the frequencies listed above will appear in the display with its current value. Change the value by using the
numeric button-pad and pressing ENTR, or use INCR and DECR to change the value by 1dB increments.
3.
Use NEXT and PREV to step through the other frequencies.
11-1
Advertisement
Table of Contents
