Dimension One Spas Californian Specifications page 2

2006 Californian Specifications
17" 43
19" 47
27" 69
Recomended location
for Electrical Inlet
Vent
11" 28
Hose Bib/
Water Drain
Note: 1. Subject to change without notice.
2. Engineering specs may differ slightly from brochure.
3. For E-Z lifter installation allow 18" clearances on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer for exact details
5. This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa.
Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Dimensions shown as inches and [centimeters] - XX" [ cm]
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.
Rev Date: 10/31/05
Doc-1511 Rev - A
2006 Californian
Architectural Specification
12" 30
Location to
install optional
export SIS
See Note 5
Vent
Control Panel
Hose
Bib/
Door Extends
Under Spa Lip
Specification, 2006, Californian
stereo speaker location
(optional)
Optional Wireless stereo
Sub-woofer location
(DOMESTIC ONLY)
Top View of Spa
THIS 3 FOOT SQUARE AREA
ON BOTTOM OF SPA, TO BE
SUPPORTED CONSISTENT WITH
THE EDGES OF SPA BASE
Equipment
Compartment
56 1/2" 144
67 1/2" 171
91 1/2" 232
stereo speaker location
(optional)
Spa Lip
Pedestal Base
75 1/2" [191]
89 "[225]
91" 231
Front View of Spa
R16"
89 "[225]
Pedastal Base
23 1/2" 60
34 1/2" 88
32" 81
15 1/2" 40
Dimension One Spas
41 Shell
91 1/2" 232
Shell
See Caution
91" 231
Skirt
Auxiliary Input
for wireless stereo
(Optional)
35 1/2" 90
Page 2 of 2