Safety Instructions - NETGEAR FSM7226RS - ProSafe Switch - Stackable Hardware Installation Manual

Managed Layer 2+ Stackable Switches FSM7226RS and FSM7250RS Hardware Installation Guide
Table 1-1. LED Descriptions (continued)
LED
Stack ID
• RJ45 Port 1-24 for
FSM7226RS
• RJ45 Port 1-48 for
FSM7250RS
(One LED per port)
Stack ports (IN and OUT)
• Copper port 25-26 for
FSM7226RS
• Copper port 49-50 for
FSM7250RS
(One LED per port)
• SFP fiber ports 25-26 for
FSM7226RS
• SFP fiber ports 49-50 for
FSM7250RS
(One LED per port)

Safety Instructions

Use the following safety guidelines to ensure your own personal safety and to help protect your
system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment, observe the
following precautions:
• Observe and follow service markings.
– Do not service any product except as explained in your system documentation.
– Opening or removing covers that are marked with the triangular symbol with a lightning
bolt could expose you to electrical shock. Only a trained service technician should service
components inside these compartments.
• If any of the following conditions occur, unplug the product from the electrical outlet and
replace the part, or contact your trained service provider:
– The power cable, extension cable, or plug is damaged.
– An object has fallen into the product.
1-4
Description
Solid Green: Display the stack ID.
SPD/Link/ACT LED
• Off: No link is established on the port.
• Green: A valid 100M link is established on the port.
• Blinking: The port is sending or receiving packets.
• Yellow: A valid 10 Mbps link is established on the port.
• Off: Stack port does not have a valid link connection.
• Green: Stack port has a valid link connection.
• Blinking: The stack port is sending or receiving packets.
SPD/Link/Act LED
• Off:No link is established on the port.
• Green: A valid 1000M link is established on the port.
• Blinking:The port is sending or receiving packets.
• Yellow: A valid 10/100M link is established on the port.
SPD/Link/Act LED
• Off:No link is established on the port.
• Green: A valid 1000M link is established on the port.
• Blinking:The port is sending or receiving packets.
• Yellow: A valid 100M link is established on the port.
v1.0, October 2008
Introduction