Table of Contents
Advertisement
3-1
Start-up Problems
The following errors may occurs when the XG2000 is started up.
If the cause of the error cannot be resolved, contact the vendor's service department.
The following explains some general errors that can occur. Check if any of these match your prob-
lem.
The XG2000 does not turn on
[Symptom] The power code is inserted to the power outlet, but the XG2000 does not power up.
[Cause]
Possible causes:
1 Loose cable, or
2 Hardware failure
[Action]
Take action in the following with the corresponding number;
1 Check that all cables are connected properly, then (if the XG2000 still doesn't turn on)
or
2 Contact the vendor's service department.
Status LED blinks, but the XG2000 does not start up
[Symptom] The XG2000 has not started within a few minutes of the XG2000 turned on.
The Status LED keeps blinking.
[Cause]
Probable hardware failure.
[Action]
Contact the vendor's service department.
Alarm LED lights, but the XG2000 does not start up
[Symptom] The XG2000 has not started within a few minutes of the XG2000 turned on.
The Alarm LED (Orange) lights.
[Cause]
Probable hardware failure.
[Action]
Contact the vendor's service department.
38
Troubleshooting
Advertisement
Table of Contents
