Table of Contents
Advertisement
GETTING ST
GETTING ST
GETTING ST
GETTING ST
GETTING STAR
AR
AR
AR
ARTED & B
GETTING STARTED
Power supply for the unit
1.
Carry out the connections for the DVD player as shown in the previous section.
2.
Insert 2 AAA batteries (supplied), into the battery compartment in the remote control, taking care to follow
the correct polarities.
3.
Connect the power cord to an AC mains outlet and press the STANDBY/ON
remote control to turn on the unit.
4.
Turn on the TV and set to the correct video-in source.
5.
To go to the standby mode, press the STANDBY/ON
player is not to be used for a long time, please disconnect the power cord.
Notes:
The effective distance for remote control operation is about 5 meters.
•
Replace the batteries when the remote control operating distance starts to reduce.
•
If the remote control is not to be used for a long time, remove the batteries to avoid damage caused by battery
•
leakage.
Precautions when using batteries
1.
Use only the size and type of batteries specified.
2.
Ensure that you follow the correct polarities marked in the battery compartment when installing the batteries.
Reversed batteries may cause damage to the remote control.
3.
Exhausted batteries must be removed to prevent possible battery leakage.
4.
Dispose of batteries properly according to environmental regulations.
Inserting a disc
1.
Press the OPEN/CLOSE button on the remote or the
open the motorized door of the disc tray.
2.
Insert a disc utill you hear a click sound, then press OPEN/CLOSE
on the front panel or the
of the disc tray. The unit will start reading the disc and start to play it, or it will
display a start menu.
Inserting a USB device
When there is no disc in the disc tray:
Insert a USB device in the USB port on the unit. The player will automatically play the files contained in the
•
USB device.
When there is a disc in the disc tray:
When the disc is playing, insert the USB device in the USB port on the unit. Press the USB button on the
•
remote control to enter USB mode.
To play the disc, press the DVD button on the remote control to enter DVD mode.
•
Notes:
Please ensure the USB device has been properly inserted in the USB port.
•
This unit cannot support NTFS format. If the device does not work with this unit, please check the file system
•
and format it in FAT or FAT32.
Although you can watch a movie immediately, to get the best from this unit, it is recommended that you carry
out.
BASIC SETUP
Press the STANDBY/ON
to enter the SYSTEM SETUP menu.
Basic Operation
1.
Press
/
to select to one of the menus below
(icons at the top of the display).
SYSTEM SETUP
•
LANGUAGE SETUP
•
VIDEO SETUP
•
AUDIO SETUP
•
2.
Press
or
to select different settings in a menu. Press
3.
Press
or
to select a new setting, then press OK to confirm the new setting.
TED & B
TED & B
TED & BASIC SETUP
TED & B
ASIC SETUP
ASIC SETUP
ASIC SETUP
ASIC SETUP
button on the remote control to close the motorized door
button to turn on the unit. Press the SETUP/EXIT button in NO DISC or STOP mode
button on the remote control or on the unit. If the DVD
button on the front panel to
or OK to confirm your selection.
GB - 10
button on the unit or on the
button
SYSTEM SETUP
SCREEN SAVER
JPEG TIME
PASSWORD
RATING
Advertisement
Table of Contents
