Novell OPEN ENTERPRISE SERVER 2.0 SP2 - UPGRADING TO OES-PLANNING AND IMPLEMENTATION GUIDE 12-2009 Implementation Manual page 91

If not:
1 Open a terminal session.
2 Change to the root user account.
3 At the shell prompt, enter the following command:
route add -net 224.0.0.0 netmask 240.0.0.0 dev interface
(eth0 is usually the interface parameter)
4 Verify that the route has been added by entering
Installing and Configuring OpenSLP
Open SLP is available as an RPM and provides UA, SA. and DA functionality. You can download a
copy from http://www.openslp.org./
SP1.
OpenSLP installs like any other RPM by using the
in the directory on the server.
/usr/sbin
After it is installed, you can configure the slpd daemon by editing the
To configure the daemon to run every time the server is booted, use the following command:
chkconfig slpd 345
To configure an OES 2 SP2 server as a DA, edit the "Static Scope and DA Configuration"
portion of the file.
To run the daemon, enter
For additional OpenSLP setup instructions, see
OES 2 SP2: Planning and Implementation
Additional Information
Novell eDirectory 8.8 Administration
route -n
(http://www.openslp.org./), It is also included with SLES 10
rpm -i
at the shell prompt.
slpd
"Setting Up OpenSLP on OES 2
Guide.
Guide, "Configuring OpenSLP for
at the shell prompt.
command. The slpd daemon is installed
/etc/slp.conf
Networks" in the
eDirectory"
Upgrading Network Services to OES
file.
91