Configuring The Driver; Deploying The Driver - Novell IDENTITY MANAGER 3.6.1 - MANUAL TASK SERVICE DRIVER Implementation Manual

4 On the Import Information Requested page, fill in the following fields:
Driver Name: Specify a name that is unique within the driver set.
Driver is Local/Remote: Select Local if this driver will run on the Metadirectory server
without using the Remote Loader service. Select Remote if you want the driver to use the
Remote Loader service, either locally on the Metadirectory server or remotely on another
server.
5 (Conditional) If you chose to run the driver remotely, click Next, then fill in the fields listed
below. Otherwise, skip to
Remote Host Name and Port: Specify the host name or IP address of the server where the
driver's Remote Loader service is running.
Driver Password: Specify the driver object password that is defined in the Remote Loader
service. The Remote Loader requires this password to authenticate to the Metadirectory server.
Remote Password: Specify the Remote Loader's password (as defined on the Remote Loader
service). The Metadirectory engine (or Remote Loader shim) requires this password to
authenticate to the Remote Loader
6 Click Next to import the driver configuration.
At this point, the driver is created from the basic configuration file. To ensure that the driver
works the way you want it to for your environment, you must review and modify (if necessary)
the driver's default configuration settings.
7 To review or modify the default configuration settings, click Configure, then continue with the
next section,
or
To skip the configuration settings at this time, click Close. When you are ready to configure the
settings, continue with the next section,

3.1.2 Configuring the Driver

There are many settings, policies, and templates that you use to configure and optimize the driver.
The ones you use depend on what you are trying to accomplish with the driver.
The driver settings, policies, and templates are explained in
and Templates," on page
After you configure the driver, it must by deployed. Continue with the next section,
Driver.

3.1.3 Deploying the Driver

After a driver is created in Designer, it must be deployed into the Identity Vault.
1 In Designer, open your project.
2 In the Modeler, right-click the driver icon
3 If you are authenticated to the Identity Vault, skip to
information:
Host: Specify the IP address or DNS name of the server hosting the Identity Vault.
Username: Specify the DN of the user object used to authenticate to the Identity Vault.
22 Identity Manager 3.6 Manual Task Service Driver Implementation Guide
Step 6.
Configuring the Driver.
31.
Configuring the Driver.
Chapter A, "Driver Settings, Policies,
or the driver line, then select Live > Deploy.
Step 5; otherwise, specify the following
Deploying the