Configuring Identity Assurance Solution; Configuring The Drivers; Configuring The Piv Life Cycle Driver - Novell IDENTITY ASSURANCE SOLUTION 3.0.2 Installation Manual

Hide thumbs Also See for IDENTITY ASSURANCE SOLUTION 3.0.2:

Table of Contents

Configuring Identity Assurance

Solution

This section describes how to use iManager to configure the drivers and how to install the User

Application server.

For overview information about each driver, see

Section 4.1, "Configuring the Drivers," on page 33

Section 4.2, "Installing the User Application Server," on page 43

Section 4.3, "Configuring E-Mail Notifications," on page 44

Section 4.4, "What's Next," on page 45

Use iManager to configure the drivers by completing the following tasks:

Section 4.1.1, "Configuring the PIV Life Cycle Driver," on page 33

Section 4.1.2, "Configuring the PIV Workflow Driver," on page 36

Section 4.1.3, "Configuring the Enrollment Driver," on page 37

Section 4.1.4, "Configuring the Honeywell SmartPlus Enrollment System," on page 39

Section 4.1.5, "Configuring the CMS Driver," on page 39

Section 4.1.6, "Configuring the PACS Integration Driver," on page 41

Section 4.1.7, "(Optional) Using Designer to Customize Your Implementation," on page 43

After the driver is installed, it is configured through iManager (See

Driver," on page 24

for instructions on how to install the driver). The PIV Life Cycle driver

configuration file creates the policies that govern how the information is synchronized.

1 In iManager, select Identity Manager Utilities > New Driver.

2 Select In a new driver set.

For the PIV Life Cycle driver, you place the driver in a new driver set. For the remaining four

drivers, you place the drivers in the driver set you create for the PIV Life Cycle driver.

Section 1.2, "Driver Overviews," on page

Section 3.5.1, "PIV Life Cycle

Configuring Identity Assurance Solution

10.

Table of Contents