Novell GROUPWISE 8 - DATABASES Manual page 62

34.1.7 Executing GWCheck from a Linux Script
The GWCheck program is located in the
directory if it has been updated, or on the GroupWise 8 DVD or downloaded GroupWise 8 image if
an updated software distribution directory is not available.
1 Make sure that GWCheck has been installed, as described in
on Linux," on page 442
2 Create a script to execute GWCheck using the following syntax:
/opt/novell/groupwise/gwcheck/bin/gwcheck --opt options_file --batch
If you did not create the options file in your home directory, specify the full path to the options
file.
If you want to include the path to an archive database, use the
3 To create an options file, see
34.1.8 GWCheck Startup Switches
The following startup switches can be used with GWCheck:
Linux GWCheck
--batch
--lang
--opt
--pa
--po
--pr
/batch
Indicates that you want to run GWCheck without a user interface. Because you do not provide the
desired options from the interface, you must provide an options file.
Syntax:
For example, to specify that you want GWCheck to run it batch mode, you would use:
Linux:
Windows:
/lang
Specifies the language to run GWCheck in, using a two-letter language code as listed below. You
must install GWCheck in the selected language in order for it to display in the selected language.
448 GroupWise 8 Administration Guide
"Saving Mailbox/Library Maintenance Options" on page
Linux GWCheck
--batch
./gwcheck --opt gwcheck.opt --batch
gwcheck /opt gwcheck.opt /batch
directory in your GroupWise software distribution
/admin
Section 34.1.3, "Using GWCheck
Windows GWCheck
/batch
/lang
/opt
/pa
/po
/pr
Windows GWCheck
/batch
--pa switch.
447.