Disabling Business Continuity Cluster Resources; Business Continuity Cluster Console Commands - Novell BUSINESS CONTINUITY CLUSTERING 1.0 - ADMINISTRATION Manual

2.10.5 Disabling Business Continuity Cluster Resources

After enabling a resource for business continuity, it is possible to disable it. You might want to do
this if you accidently enabled the resource for business continuity, or if you no longer want a specific
resource to potentially run on another cluster.
If you enabled a cluster resource for business continuity and you want to disable it, do the following:
1 Disable the resource for business continuity.
2 Wait for DirXML to synchronize the changes.
3 Delete the cluster resource object on the clusters where you no longer want the resource to run.

2.10.6 Business Continuity Cluster Console Commands

Novell Business Continuity Cluster (BCC) Services provides some server console commands to
help you perform certain business continuity cluster-related tasks. Some of the commands can be
used both with Novell Cluster Services and with Novell Business Continuity Clustering. The
following table lists the BCC-related server console commands and gives a brief description of each
command. For other cluster console commands, see
the Novell Cluster Services 1.7 Administration
to the BCC console by selecting it from the console screen list or by entering cluster console
at the command prompt. Then enter cluster followed by the command. For example, if this cluster is
a member of a business continuity cluster, and you want to see this cluster's peer clusters, enter
cluster view at the server console. You can also enter help cluster at the console prompt
to get information on the commands and their functions.
BCC Console Commands
CLUSTER CREDENTIALS {cluster}
42 Novell Business Continuity Cluster Services 1.0 Administration Guide
1a Start Internet Explorer 5 or later and enter the URL for iManager.
The URL is http://server_ip_address/nps/imanager.html. Replace server_ip_address with
the IP address or DNS name of the NetWare 6.5 server that has iManager and the DirXML
preconfigured templates for iManager installed.
1b Enter your username and password.
1c In the left column, click Cluster Administration, then click the Configuration link.
1d Specify the cluster name or browse and select it.
1e Select the desired cluster resource from the list of Cluster objects
1f Click the Properties link (not the Properties button), then click the Business Continuity
tab.
1g Uncheck the Enable Business Continuity Features check box.
This could take from 30 seconds to one minute, depending on your configuration.
Novell Cluster Services Console Commands
GuideTo execute a cluster console command, switch
Description
Lets you change the administrator username and
password that this cluster will use to connect to the
specified peer cluster. The cluster you specify must
be a member of a cluster that has already been
enabled for Business Continuity Clustering.
in