Assigning A J2Ee Agent To A Cluster - Novell ACCESS MANAGER 3.1 SP1 - AGENT GUIDE Manual

3 Specify the following information:
Cluster Name: Specify a name for the cluster configuration.
Type: Specify if the J2EE agent is a WebLogic Agent, JBoss Agent, or WebSphere Agent. A
list of servers is displayed, depending on the selection you make here.
Primary Cluster Server: Select a primary server from the list of servers displayed.
4 Click OK.
The status icons for the configuration and the J2EE Agent should turn green. It might take several
seconds for the J2EE Agent to start and for the system to display a green status.

3.3 Assigning a J2EE Agent to a Cluster

After you create a cluster, you can assign other J2EE Agents to it. A cluster uses any shared settings
you have specified for the primary cluster server.
1 In the Administration Console, click Devices > J2EE Agents.
2 On the Servers page, select the server's check box, then choose Actions > Assign to Cluster.
To select all the servers in the list, select the top-level Server check box.
64 Novell Access Manager 3.1 SP1 Agent Guide