Installing The Jboss Agent Through The Console - Novell ACCESS MANAGER 3.1 SP1 - AGENT GUIDE Manual

16 Specify the following information:
Application Server Directory: Specify the directory where you have installed the JBoss
server.
Enter the JBoss server configuration to deploy to: Specify the name of the server
configuration folder.
17 Click Next. The JCC Dependencies page is displayed.
18 Click Install to install the dependent JCC packages.
19 Review the installation summary, then click Install to install the agent.
20 Click Done when the installation is complete.
21 When the installation completes, start JBoss.
The agent is not imported into the Administration Console until the JBoss server is running.
22 To verify the installation of the agent, see
on page

1.3.4 Installing the JBoss Agent Through the Console

1 Download the J2EE agent for JBoss from
2 Enter the following command in the command prompt to run the installer on the console:
<filename> -i console
Replace <filename> with the name of the J2EE agent installer.
3 Review the License Agreement, then press
4 Specify an absolute path to install the Novell J2EE agent components, or press Enter to
continue with the default installation path.
20 Novell Access Manager 3.1 SP1 Agent Guide
42.
Section 1.6, "Verifying If a J2EE Agent Is Installed,"
Novell (http://www.novell.com/products).
to accept it.
Y