PowerSoft
2.4 H
OW CAN
THE POWER ANALYSER MEASURED VARIABLES
The temperature measurements can be only supplied by UDM or USC
panel meters/conditioners equipped with the BQTRX input module.
The configurator can recognise the temperature meters automatically and
associate them to a particular analyser. The automatic procedure is feasible
only if the following rules are respected:
Example: Analyser WM3 =1 è Temp. meter UDM= 100+1 = 101
Manually, it is possible to associate a temperature meter to any instrument
setting the following parameters:
1.
2.
3.
4.
measurement
Note that a temperature meter can be associated to more than one analyser
at the same time.
PowerSoft – Instruction manual
I
ADD THE TEMPERATURE TO
1. Temperature meter and analyser are to be
installed in the same communication line
2. The Modbus address of the analyser (for
example S) is to be between 1 and 100
3. The Modbus address of the temperature meter
is to be S+100
Enable the temperature measurement
Temperature meter driver name
Temperature meter Modbus address
Number of decimals on the temperature
?
24