Table of Contents
Advertisement
PowerSoft
2.2 M
Y SYSTEM IS BASED ON SERIAL LINES
E
AND
THERNET LINES
TOTALLY AUTOMATED WAY
No, but it is possible to do it in a semi-automatic way, using 3 different
wizards and manually editing the IP addresses of the Ethernet lines.
PowerSoft – Instruction manual
. C
I
AN
CONFIGURE IT IN A
?
1.
configurator
"communication ports" section.
2.
wizard to find any serial COM line
(see previous question).
3.
add any Ethernet port using the
"Add port" button, and edit its IP
address and the relevant port (502
is the default value).
4.
"meters" section and choose
"Automatic".
5.
configurator searches for all the
instruments connected to any
configured
scanning time the list of the found
instruments will be shown.
6.
"Synoptic" section and choose
"Regenerate".
7.
system asks for the list of the pages
to be regenerated.
Launch the
and
select
the
Run
the
Manually
Open the
The
ports.
After
the
Open the
The
22
Advertisement
Table of Contents
