Cpu Configuration - ASROCK 775i65G R2.0 User Manual

Main Advanced
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.3.1 3.3.1 3.3.1 CPU Configuration 3.3.1 3.3.1 CPU Configuration CPU Configuration CPU Configuration CPU Configuration
Advanced
CPU Configuration
CPU Host Frequency
Actual Frequency (MHz)
Boot Failure Guard
Spread Spectrum
Ratio Status
Ratio Actual Value
Enhance Halt State
Max CPUID Value Limit
Intel (R) Virtualization tech.
CPU Thermal Throttling
No-Excute Memory Protection
Hyper Threading Technology
Intel (R) SpeedStep(tm) tech.
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
CPU Host Frequency
While entering setup, BIOS auto detects the present CPU host frequency of
this motherboard. The actual CPU host frequency will show in the following
item.
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
Spread Spectrum
This item should always be [Auto] for better system stability.
Ratio Status
This is a read-only item, which displays whether the ratio status of this
motherboard is "Locked" or "Unlocked". If it shows "Unlocked", you will find
an item Ratio CMOS Setting appears to allow you changing the ratio value
of this motherboard. If it shows "Locked", then the item Ratio CMOS Set-
ting will be hidden. If you use the ratio value to time the CPU frequency, it will
be equal to the core speed of the installed processor.
2 4 2 4 2 4
2 4 2 4
BIOS SETUP UTILITY
H/W Monitor Boot Security
Configure CPU
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC
BIOS SETUP UTILITY
Select how to set the
CPU host frequency.
[Auto]
[200]
[Enabled]
[Auto]
: Locked
: 16
Select Screen Select Screen
[Disabled]
Select Item Select Item
[Disabled]
+- +- Change Option Change Option
[Enabled]
F1 F1 General Help General Help
[Enabled]
F9 F9 Load Defaults Load Defaults
[Disabled]
F10 F10 Save and Exit Save and Exit
[Enabled]
ESC ESC Exit Exit
[Auto]
Exit
Select Screen
Select Item
Exit