If a web page does not open, close and reopen the browser and enter http://routerlogin.net
in the address bar.
Connect any additional wired PCs to your modem router by inserting an Ethernet cable from
5.
a PC into one of the three remaining LAN ports.
If you are an advanced user who wants to set up the modem to run
Note:
in "pure bridge" or Modem mode, you need to log in to the modem
and change the Device Mode setting to Modem mode. See
the Device Mode
Verify the Cabling
Verify that your modem router is cabled correctly by checking the modem router LEDs. Turn
on the modem router by pressing the On/Off button on the back.
The Power LED is green when the modem routeris turned on.
•
The LAN ports are green for each PC cabled to the modem router by an Ethernet
•
cable.
The wireless LED is green when the modem router is turned on.
•
The DSL LED is green when you have a DSL connection.
•
The Internet LED is red when there is no Internet connection.
•
Turn on your computer. If software usually logs you in to your Internet connection, do not run
that software. Cancel it if it starts automatically.
Verify that the LAN
router by an Ethernet cable.
N300 Wireless ADSL2+ Modem Router DGN2200v3
on page 99.
LEDs (1 through 4) are lit for any computers cabled to the modem
Hardware Setup
16
Change