Setting The Speaker Impedance (U.s.a. And Canada Models Only) - Yamaha RX-V363 - AV Receiver Owner's Manual

Connections
■ Connecting to the FRONT A terminals
2
1
3
1
Loosen the knob.
2
Insert the bare end of the speaker wire into
the slit on the terminal.
3
Tighten the knob to secure the wire.
Connecting the banana plug
(except Europe, Russia, Korea, and Asia models)
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables. First, tighten the
knob and then insert the banana plug connector into the
end of the corresponding terminal.
Banana plug
■ Connecting to the FRONT B, CENTER,
and SURROUND terminals
1
Press down the tab.
2
Insert the bare end of the speaker wire into
the hole on the terminal.
3
Release the tab to secure the wire.
12
En
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
Setting the speaker impedance
(U.S.A. and Canada models only)
Caution
If you are to use 6 ohm speakers, set "SP IMP." to
"6ΩMIN" as follows BEFORE using this unit.
1
Make sure this unit is turned off.
See page 19 for details about turning on or off this
unit.
Press and hold J TONE CONTROL and
2
then press A STANDBY/ON to turn on this
unit.
This unit turns on, an the advanced setup menu
appears in the front panel display.
Press K PROGRAM l / h repeatedly to
3
select "SP IMP.".
The following display appears in the front panel
display.
S P I M P . - 8 M I N
Press L STRAIGHT repeatedly to select
4
"6ΩMIN".
The following display appears in the front panel
display.
S P I M P . - 6 M I N
Press A STANDBY/ON to confirm your
5
selection and set this unit to the standby
mode.
Note
The setting you made is reflected next time you turn on this unit.