Extended Functionality That Can Be Configured As Needed (Advanced Setup Menu); Displaying/Setting The Advanced Setup Menu; Setting The Impedance Of Speakers (U.s.a. And Canada Models Only); Avoiding Crossing Remote Control Signals When Using Multiple Yamaha Receivers - Yamaha HTR-5063 Owner's Manual

Extended functionality that can be configured as needed (Advanced Setup menu)

The Advanced Setup menu can be used for unit initialization and other useful extended functions. The Advanced Setup menu can be operated as follows.
Displaying/Setting the Advanced Setup
menu
Switch this unit to the standby mode.
1
Press A while pressing and holding STRAIGHT on
2
the front panel.
Release the keys when "ADVANCED SETUP" is displayed on
the front panel display.
After approximately a few seconds, the top menu items are
displayed.
A
YPAO MIC
INFO MEMORY PRESET
BD
DVD
PHONES INPUT TONE CONTROL
SILENT CINEMA
PROGRAM l / h
Use PROGRAM l / h to select the item to be set
3
from the following items.
In the Advanced Setup menu, you can set the following settings.
J
1 : U.S.A. and Canada models only.
J
2 : Asia and General models only.
J
3 : For detailed procedures of speaker impedance settings, refer to "(U.S.A. and
Canada models only) Changing speaker impedance"
J1
SP IMP.
REMOTE ID
BI-AMP
MON.CHK
TU J2
INIT
Press STRAIGHT repeatedly to select the value you
4
want to change.
Switch this unit to the standby mode, and then
5
switch it on again.
STRAIGHT
The settings become effective and the unit is powered on. If
initialization is selected, it will be performed when the unit is
powered on again.
FM AM
Setting the impedance of speakers
SCENE
TV CD RADIO
(U.S.A. and Canada models only)
PROGRAM STRAIGHT
SP IMP. -8 MIN
Changes the unit settings depending on the impedance of the
speakers connected.
6 MIN
8 MIN (Default)
(☞p. 12).
Sets the impedance of speakers.
Changes the remote control ID of a receiver.
Switches the bi-amp connections on or off.
Removes the up-scaling limitation on HDMI video
output.
Selects one of the following FM/AM frequency steps.
Initializes various settings for this unit.
J3
Select the impedance when 6Ω speakers are
connected.
Select the impedance when speakers above 8Ω are
connected.
Avoiding crossing remote control signals
when using multiple Yamaha receivers
REMOTE ID -ID1
The remote control of the unit can only receive signals from a
receiver which has an identical ID (remote control ID). When using
multiple Yamaha AV receivers, you can set each remote control
with a unique remote control ID for its corresponding receiver.
On the contrary, if you are setting the same remote control ID for
all receivers, you can use one remote control to operate 2 receivers.
ID1 (Default)
Receives the remote control signals set in ID1.
ID2
Receives the remote control signals set in ID2.
ID1 is set for both remote control and receiver by default. To
avoid crossing remote control, change the remote control ID for
both remote control and receiver.
SETUP
Continues to the
next page
66
En